Currently flooring methods include direct bonding method, and the following three suspension laying the keel laying method, and in geothermal environments using the most appropriate method for the laying of the keel laying method and suspension lay method, among which the most commonly used method of laying suspension. Before laying the ground after the first leveling film is then covered with moisture-proof, moisture-proof pad and then direct pavement floor. Suspension laying method is mainly divided into on-site inspections, laying cushion, shop floor plastic wood uses for wood floors test and install the four steps. When pavement geothermal floor, neither damage geothermal pipelines, and can not influence the heat transfer surface, so Cushion thickness should be maintained at 12-15 mm, otherwise it will affect the cooling effect. Pavement leveling the ground is the key Before proceeding to heat the floor coverings, the room must meet the following conditions can be carried out paving work.

The ground must remain flat, indoor environment dry and no water seepage, leakage and other phenomena occur, drain kept clear. The most vulnerable part of the above question is ground flatness problem. If the ground level is not only for the old house, some pre-construction new homes caused by inadequate uneven ground, it is also required for leveling work. Whether the ground needs leveling flooring generally consists responsible remind the owners, if laid side before laying did not do to remind the obligation, to find the problem after the pavement is caused by uneven ground, it shall bear the corresponding responsibility. Prior to the pavement while also check ground clearance and Door leaf.

Door and the ground should maintain a certain distance, otherwise it will rub the ground. Paving workers but also ensure that the floor after completion of the pavement for 5 mm gap with the ground, if it is less than 5 mm will cause inconvenience to the door switch. And in the laying of the cushion, and the direction of the floor mat to vertical. Pay attention to the gap distance again flooring During geothermal floor coverings, the first three rows are required to test the shop, that can not be sizing pavement. In terms of the direction of the pavement is not strictly required, generally along most affordable product for decks the length of the room pavement, if the owners have special requirements, can also be based on the feasibility pavement. Row by row from left to right should ensure the pavement grooves toward the wall, placed between the floor and the wall of the wedge to leave some gaps stretching, stretching the gap should be maintained between 8-12 mm. Note also that in the pavement, if the last row of a cutting remaining portion of the floor greater than 200 mm, must be used for the next row of the starting block, in order to ensure a certain area and adjacent plates wrong seam wrong seam ends greater than 200 mm and less than 200 mm if you can give.