YogiSource.com my account | view cart | customer service
 Search:    
Welcome to the new Yoga.com Forums home!
For future visits, link to "http://www.YogiSource.com/forums".
Make a new bookmark.
Tell your friends so they can find us and you!

Coming soon ... exciting new changes for our website, now at YogiSource.com.

Search | Statistics | User Listing View All Forums
You are logged in as a guest. ( logon | register )



Variable pump pressure adjustment steps
Moderators: Moderators

Jump to page : 1
Now viewing page 1 [25 messages per page]
View previous thread :: View next thread
   Yoga -> General YogaMessage format
 
hhm1020
Posted 2020-10-21 4:30 AM (#256971)
Subject: Variable pump pressure adjustment steps


Expert Yogi

Posts: 8285
500020001000100100252525

1) Adjust the pressure of unloading valve DA10, relief valve DB10 or DB20 to the minimum.




2) Check in the slurry inlet valve and close the slurry outlet valve to the minimum, that is, the slurry flow rate of the pump is small at this time.




3) Start the motor, slowly adjust the relief valve DB10 or DB20 to adjust the mud pressure to be about 0.1Mpa-0.2Mpa less than the required pressure.




4) Slowly adjust the unloading valve DA10 until the unloading valve has pressure (that is, the pressure gauge corresponding to the unloading valve shows less than 0Mpa).




5) If the state cannot be reached, adjust the unloading valve and the relief valve according to the above steps 3 and 4 until this state.




6) After adjusting the unloading valve, tighten the nut. (Note: The pressure of the unloading valve should be zero at this time, if it is not zero, then slightly lower the pressure of the unloading valve, and the pressure will only be displayed when it reaches zero).




7) Open the slurry valve to start normal operation.
Related products:
Screw vacuum pump used in forming vacuum of refrigerator liner
Rotary vane vacuum pump in drying and packaging of organic yellow flowers
Green Environmental Protection Dryer Equipment
Mushroom Drying Equipment Of Drying Technology


Top of the page Bottom of the page
Jump to page : 1
Now viewing page 1 [25 messages per page]
Jump to forum :
Search this forum
Printer friendly version
E-mail a link to this thread


(Delete all cookies set by this site)